Monogram Range Error Code F5

The F5 error code on a Monogram range indicates that the relay drive circuit has been lost. This circuit is responsible for controlling the operation of the oven’s relays, which are responsible for switching power to the oven’s components.

There are a few possible causes of the F5 error code. These include:

• Relay failure: The relay is a component that switches power to the oven’s components. If the relay fails, it will not be able to pass power to the components, which will cause the F5 error code to be displayed.
• Relay drive circuit failure: The relay drive circuit is responsible for controlling the operation of the relay. If the relay drive circuit fails, it will not be able to send the correct signals to the relay, which will also cause the F5 error code to be displayed.
• Control board failure: The control board is the component that controls the operation of the oven. If the control board fails, it may not be sending the correct signals to the relay drive circuit, which can also cause the F5 error code to be displayed.

If you see the F5 error code on your Monogram range, you can try the following troubleshooting steps:

1. Check the relay: The relay is the easiest component to check. To do this, unplug the range and remove the back panel. Locate the relay and look for any signs of damage, such as burnt wires or melted components. If you find any damage, the relay will need to be replaced.
2. Check the relay drive circuit: The relay drive circuit can be checked using a multimeter. To do this, set the multimeter to the resistance setting and connect the leads to the terminals of the relay drive circuit. The resistance should be within the specified range for your range model. If the resistance is outside of the specified range, the relay drive circuit will need to be replaced.
3. Check the control board: If you have checked all of the other possible causes and the F5 error code is still present, the control board may be the problem. To check the control board, you will need to contact a qualified appliance repair technician.

Replacing the Relay or Relay Drive Circuit

If the relay or relay drive circuit needs to be replaced, you can purchase a new part from a Monogram authorized dealer. To replace the part, follow the instructions in your range’s owner’s manual.

Additional Information

• The F5 error code is a general error code that can be caused by a variety of factors. If you are not comfortable troubleshooting the issue yourself, it is best to contact a qualified appliance repair technician.
• The relay drive circuit is a complex component that is difficult to troubleshoot without specialized tools. If you are not comfortable troubleshooting the relay drive circuit yourself, it is best to contact a qualified appliance repair technician.